|
Tools For Laying Laminate Floors
Tools for laying laminate floors must be prepared and completed before starting to lay the laminate floors. In that way, the installation can be done continuously without unnecessary delay in case certain tools cannot be located. Preparation is always the best key for successful placement of laminate floors. List of tools for laying laminate floors are often provided by manufacturers of laminate flooring. This is to allow the installer to properly install each plank without causing possible damage on the laminate floorings. Hence the manufacturers recommendation of tools must always be observed and followed. To ensure proper laying of the laminate floorings here are some of the recommended tools and accessories that can be used. Glue, tapping block S-1814, pull bar S-1812 and spacers S-1813. They are used to make the laminate floorings effectively hold by the subfloors. You need to have laminate floorings coordinated transitions and molding pieces like quarter-round molding, end molding, t-molding, reducer strip, flush stairnose, baby threshold, over-the-top step nose and wall base. Tools like carpenter squares and tape measure is also essential to accurately get the necessary width and length of the laminate flooring that will perfectly fit the subfloors. 2 (5.1 cm) Wide polyethylene tape, hammer and 6d nails to fasten and keep the laminate floorings in place especially on laminate floor installation on stairs. Utility knife and safety glasses, NIOSH-Designated dusk mask and 100% silicone caulk in case the place or room where the laminate floor has excessive moisture. You will also need bucket of warm water and clean cotton cloths for cleaning the laminate flooring. Touch-up kit/filler kit, plastic scraper to remove excess glue, router and router bit like 7mm and 8mm laminate:S-1824 and 11mm laminate:S-1828. Laminate flooring splines 7mm and 8mm laminate: S-1825 and 11mm laminate: S-1829. You will also need drill, saws like table saws, miter saw, circular saw, hand saw and jigsaw, dividers, chalk line, clamping system and pocket plane. The aforesaid materials and tools for laying the laminate floor are mostly available on seller or manufacturer of laminate floorings but not all these tools will be used whenever installing laminate flooring. Some tools for laying laminate floors are required only in special circumstances. Hence a professional installer is required to ensure the application and correct usage of the tools for laying the laminate floor effectively. Tools for laying the laminate floors also depend on the type and quality of laminate floorings. There are some types or brands of laminate flooring that does not require tools because they are specially created with interlocking system. This will allow the owner to install it directly without the need of tools. But in general tools are required so when planning to install laminate floorings make sure to ask the seller or manufacturer on how it must be installed as well as the necessary tools in laying the chosen laminate floorings. |